Carbon Fiber Cannon Barrel and Glossy Fiber Cannon Barrel are two components for the front part of the Airsoft Rifle.
The Product is composed by a total of six elements:
– a front pipe, composed by a nut threaded in M24x1,5, a front cup threaded in M14x1LH, made out of Anticorodal 6082T6 aluminum alloy and the pipe. Inside the pipe is located the alignement ring that grant the perfect alignement of the inner barrel. The front pipe is threaded to allow customer to fit the dedicated Conversion that can be used to attach the tracer directly on the top of the Carbon Fiber Cannon Barrel or Glossy Fiber Cannon Barrel;
– a barrel nut, M32x1,5 threaded that allow to block the proper barrel hop up housing chamber;
– the housing chamber for the hop up chamber;
– 3 alignement grains, specificly made in titanium.
All the aluminum parts are anodized in different colors.
To grant the perfect alignement of the Inner Barrel, as mentioned there is a ring, made out of Delrin (POM, high slip plastic material) and have a internal diameter of 8,60mm with a tight tollerances of -0 / +0,05mm.
The nut is specifically realized with the two guides for the Hop up chamber in the measurement of 2,45mm +/-0,05mm allowing you to get a very good alignement of the hop up chamber. It is possible to be needed to file it a bit in case you use a plastic hop up chamber avoiding wobbling movements.
The Inner Barrel lenght must be enough to reach the alignement diameter of the front cup or the alignement can’t be granted.
The alignement grains are three and are custom made under my design having an head of 3,20mm +0/-0,05 mm of tollerance, granting a very good alignement without having issues from a too much gap between the grains and the upper receiver guides.
The weight can vary from a minimum of 90g based on the lenght.
How “Lenght” stand for?
Here how Lenght is supposed to be taken:
(Note: In this picture is not visible the alignement ring, that is positioned right behind the front threaded cup).
